Coil-Over Accessories

Shock Extended Eye
Increasing vehicle ride height without disrupting the correct balance of shock travel has never been simpler. Our direct-replacement, billet-aluminum shock mounts feature a 1” extended body, and perfect fit for existing VariShock polyurethane bushings. Mounts simply screw onto the top of the shock’s piston rod and are secured by a jam nut. Extended eyes can be used with any VariShock coil-over shock to raise ride height approximately 1-1/4”. Proper suspension travel and clearance must be verified prior to installation.

VAS 512-2-2

Spring-Seat Thrust Bearings
Thrust bearings are used at the lower spring seat to reduce friction when adjusting ride height. New stainless “cap-style” seats, a VariShock exclusive, enclose the thrust bearing to keep dirt out.

VAS 513-100

Spanner Wrench
Also available is an exclusive spanner wrench, incorporating four tangs, which will not slip off the lower spring seat because it engages the seat in four places (not one, like common spanners).

899-012-201

Coil-Over Spring Compressor
The VariShock coil-over-spring compressor greatly eases lower spring-collar adjustment on high-preload or high-rate applications. Heavy-duty plates at each end fit 2-1/2” inside-diameter coil springs of 130 lb., rate or greater, with a maximum spring height of 14”.

VAS 200

Related Links:

• Front Coil-Over Conversion
• g-Bar Canted-4-Bar Suspension System

All specifications and prices listed throughout the website and linked documents are subject to change.

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov

© 2018 Total Control Products - A Chris Alston's Chassisworks, Inc. Brand

Toll Free: 888.388.0298